The sides have been stitched and the ends are nearly closed. These were much easier to align and stitch than the bottom panels. The curves and twists are more gentle. It's either that or we are quick learners, probably a combination of the two. This picture also shows the new Styrofoam blocks to support the kayak on my work bench. This give us clearance to work under the boat with easy access to wires on bottom. The big advantage is providing a super stable cradle for the boat to sit in, eliminating the annoying rocking back and forth we dealt with yesterday. Fortunately I was smart enough to trace full size patterns of the hull forms in cardboard prior to wiring them into the hull. Then transferring the patterns to the Styrofoam blocks made for a perfect support fit. One drawback to be aware of... even after vacuuming the work area I still have a few little white beads static-clinging about. Will have to make sure that none of these find their way in to the epoxy or varnish down the road.
Above you see the stern almost closed, with the transom ready to be wired. Today proved that copper wires stitches are sharp and will draw blood. Gotta love it!
Mo & Ang
You've put your blood and sweat into it. No tears though, ok?
ReplyDeleteHa! I will save the tears for launch day
ReplyDelete